運用コマンドレファレンス Vol.3


clear ipv6 duplicate-address

指定されたインタフェースに設定されているIPv6アドレスの重複状態を解除して,Duplicate Address Detectionを再実行します。

[入力形式]

clear ipv6 duplicate-address interface <interface type> <interface number>

[入力モード]

一般ユーザモードおよび装置管理者モード

[パラメータ]

interface <interface type> <interface number>

指定したインタフェースに設定されているIPv6アドレスの重複状態を解除して,Duplicate Address Detectionを再実行します。

<interface type> <interface number>には,次に示すインタフェース種別グループに対応するインタフェース名およびインタフェース番号を指定できます。詳細は,「パラメータに指定できる値」の「■インタフェースの指定方法」を参照してください。

  • イーサネットインタフェース

  • イーサネットサブインタフェース

  • ポートチャネルインタフェース

  • ポートチャネルサブインタフェース

  • VLANインタフェース

  • マネージメントポート

[実行例]

図3‒9 IPv6アドレスの重複状態解除およびDuplicate Address Detection再実行
> clear ipv6 duplicate-address interface gigabitethernet 1/1
>

[表示説明]

なし

[通信への影響]

なし

[応答メッセージ]

表3‒10 clear ipv6 duplicate-addressコマンドの応答メッセージ一覧

メッセージ

内容

The command cannot be executed in the standby system.

このコマンドは待機系では実行できません。

The command cannot be executed. Try again.

コマンドを実行できません。再実行してください。

The command is not authorized by the RADIUS/TACACS+ server or the configuration.

このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。

The specified interface does not exist.

指定したインタフェースは存在しません。指定パラメータを確認して再実行してください。

The specified interface type is incorrect.

指定した<interface type>が不正です。指定パラメータを確認して再実行してください。

[注意事項]

  1. 本コマンド実行後にアドレスの重複状態を確認する場合は,show ipv6 interfaceコマンドまたはshow ip-dual interfaceコマンドを実行してください。

  2. 本コマンドを実行すると,次のアドレスに対してDuplicate Address Detectionが再実行されます。

    • Duplicate Address Detectionを実行中のため使用できる状態になっていないIPv6アドレス

    • 重複を検出して使用できない状態になったIPv6アドレス