clear axrp preempt-delay
マスタノードの経路切り戻し抑止状態を解除します。
[入力形式]
clear axrp preempt-delay <ring id> [-f]
[入力モード]
一般ユーザモードおよび装置管理者モード
[パラメータ]
- <ring id>
-
指定したリングIDの経路切り戻し抑止状態を解除します。
指定できる範囲は1〜65535です。
- -f
-
確認メッセージを出力しないで,経路切り戻し抑止状態を解除します。
- 本パラメータ省略時の動作
-
確認メッセージを出力します。
[実行例]
> clear axrp preempt-delay 1 Are you sure you want to resume failure recovery? (y/n): y > |
> clear axrp preempt-delay 1 -f > |
[表示説明]
なし
[通信への影響]
経路切り戻し抑止状態のリングIDに対して本コマンドを実行した場合,該当リングIDの抑止状態を解除して,経路の切り戻し動作を実施します。このとき,経路の切り戻し動作に伴って,該当リングIDのVLANグループに参加しているVLANの通信が一時的に停止します。
[応答メッセージ]
メッセージ |
内容 |
---|---|
The command cannot be executed in the standby system. |
このコマンドは待機系では実行できません。 |
The command cannot be executed. Try again. |
コマンドを実行できません。再実行してください。 |
The command is not authorized by the RADIUS/TACACS+ server or the configuration. |
このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。 |
The connection with the Ring Protocol program failed. Retry the command. If this problem occurs repeatedly, use 'restart axrp' to restart the program. |
Ring Protocolプログラムとの通信に失敗しました。コマンドを再実行してください。頻発する場合は,restart axrpコマンドでRing Protocolプログラムを再起動してください。 |
The Ring Protocol is not configured. |
Ring Protocolが設定されていません。コンフィグレーションを確認してください。 |
The specified ring ID is not configured. (ring ID = <ring id>) |
指定したリングIDは設定されていません。コンフィグレーションを確認してください。 <ring id>:リングID |
The specified ring ID is not preempt delay state. (ring ID = <ring id>) |
指定したリングIDは経路切り戻し抑止状態ではありません。 <ring id>:リングID |
[注意事項]
なし