コンフィグレーションコマンドレファレンス Vol.1
表22-12 スパニングツリーのエラーメッセージ
メッセージ 内容 Can not configure spanning-tree when gsrp is configured. GSRPの設定があるため,スパニングツリーが設定できません。 Cost is over 65535, please set up in 1 to 65535 or set pathcost method to long. costの値が65535以上です。costの値を1から65535の範囲で設定するか,pathcost methodをlongにしてください。 Inconsistency is found between the vrf mode and the spanning-tree configuration. VRFの設定があるため,スパニングツリーを設定できません。 Maximum number of MST instance are already defined. MSTインスタンス数がすでに最大数設定されています。設定できるMSTインスタンスは最大16です。 Pathcost method is short, please set up in 1 to 65535 or set pathcost method to long. pathcost methodがshortです。costの値を1から65535の範囲で設定するか,pathcost methodをlongにしてください。 Relations between PVST+ and l2protocol-tunnel stp configuration are inconsistent. PVST+とBPDUフォワーディングは同時に設定できません。 Relations between PVST+ and the protocol-vlan or mac-vlan configuration are inconsistent. PVST+と,プロトコルVLANまたはMAC VLANは同時に設定できません。 spanning-tree: maximum number of MST instance are already defined. MSTインスタンス数がすでに最大数設定されています。設定できるMSTインスタンスは最大16です。
All Rights Reserved, Copyright(C), 2006, 2018, ALAXALA Networks, Corp.