14.1.3 装置の状態確認
運用コマンドshow systemで装置の動作状態や搭載メモリ量などを確認できます。次の図に例を示します。
> show system
Date 20XX/08/10 17:53:12 UTC
System: AX4630S-4M, OS-L3CA Ver. 11.14
Node : Name=
Contact=
Locate=
Elapsed time : 00:45:03
LED Brightness mode : normal
Machine ID : 0012.e201.023a
Power redundancy-mode : check is not executed
Power slot 1 : active PS-M(AC)
Fan : active No = Fan1(1) Speed = normal, Direction = F-to-R
PS : active
Lamp : Power LED=green , ALM1 LED=light off
Power slot 2 : active PS-M(DC)
Fan : active No = Fan1(1) Speed = normal, Direction = F-to-R
PS : active
Lamp : Power LED=green , ALM1 LED=light off
Fan slot 1 : active FAN-M
Fan : active No = Fan3(1) Speed = normal, Direction = F-to-R
Fan slot 2 : active FAN-M
Fan : active No = Fan4(1) Speed = normal, Direction = F-to-R
Fan slot 3 : active FAN-M
Fan : active No = Fan5(1) Speed = normal, Direction = F-to-R
Main board : active
Boot : 20XX/08/10 17:08:19 , operation reboot
Fatal restart : CPU 0 times , SW 0 times
Lamp : Power LED=green , Status LED1=green
Board : CPU=PowerPC 1200MHz , Memory=2,097,152kB(2048MB)
Management port: active up
1000BASE-T full(auto) 0012.e238.3401
Temperature : normal(26degree)
Flash :
user area config area dump area area total
used 242,341kB 324kB 0kB 242,665kB
free 168,787kB 241,081kB 130,798kB 540,666kB
total 411,128kB 241,405kB 130,798kB 783,331kB
MC : enabled
Manufacture ID : 00000003
259,176kB used
1,671,616kB free
1,930,792kB total
System traffic-mode : wire rate
0/1 : disable NIF3 : notconnect
0/2 : disable NIF4 : enable
0/3 : enable NIF1 : notconnect
0/4 : enable NIF2 : 2/21-24 disable
Device resources
Current selected swrt_table_resource : l3switch-1
Current selected swrt_multicast_table : Off
Current selected unicast multipath number: 16
IP routing entry :
Unicast : current number=6 , max number=13312
Multicast : current number=0 , max number=2048
ARP : current number=0 , max number=45054
IPv6 routing entry :
Unicast : current number=0 , max number=0
Multicast : current number=0 , max number=0
NDP : current number=0 , max number=0
Multipath table entry : current number=0 , max number=256
MAC-Address table entry : current number=1 , max number=98304
System Layer2 Table Mode : mode=0
Flow detection mode : layer3-mirror-5
Used resources for filter inbound(Used/Max)
MAC IPv4 IPv6
n/a 0/ 512 0/ 512
Used resources for QoS(Used/Max)
MAC IPv4 IPv6
n/a 0/ 256 n/a
Used resources for UPC(Used/Max)
MAC IPv4 IPv6
n/a 0/ 256 n/a
Used resources for Mirror inbound(Used/Max)
MAC IPv4 IPv6
2/ 256 3/ 256 0/ 256
Used resources for TCP/UDP port detection pattern
Resources(Used/Max): 1/32
Destination Port Used
100-200 : -/ -/mirror
Flow detection out mode : layer3-2-out
Used resources for filter outbound(Used/Max)
MAC IPv4 IPv6
0/ 256 2/ 256 0/ 256
Flow action change
cos : enable
arp discard class : enable
arp reply cos : enable
> |
運用コマンドshow environmentでファン，電源，温度の状態，累積稼働時間を確認できます。ファンの運転モードはコンフィグレーションコマンドsystem fan modeで設定できます。次の図に例を示します。
> show environment
Date 20XX/08/10 17:41:42 UTC
Power slot 1 : PS-M(AC), Direction = F-to-R
Power slot 2 : PS-M(DC), Direction = F-to-R
Fan slot 1 : FAN-M, Direction = F-to-R
Fan slot 2 : FAN-M, Direction = F-to-R
Fan slot 3 : FAN-M, Direction = F-to-R
Fan environment
Power slot 1 : Fan1(1) = active
Speed = normal
Power slot 2 : Fan2(1) = active
Speed = normal
Fan slot 1 : Fan3(1) = active
Speed = normal
Fan slot 2 : Fan4(1) = active
Speed = normal
Fan slot 3 : Fan5(1) = active
Speed = normal
Fan mode : 1 (silent)
Power environment
Power slot 1 : active
Power slot 2 : active
Temperature environment
Main : 27 degrees C
NIF1 : notconnect
NIF2 : 30 degrees C
NIF3 : notconnect
NIF4 : 33 degrees C
Warning level : normal
Accumulated running time
Main : total : 20 days and 0 hours.
critical : 0 days and 0 hours..
Power slot 1 : total : 10 days and 12 hours.
critical : 0 days and 0 hours.
Power slot 2 : total : 9 days and 23 hours.
critical : 0 days and 0 hours.
Fan slot 1 : total : 3 days and 6 hours.
critical : 0 days and 18 hours.
Fan slot 2 : total : 3 days and 6 hours.
critical : 0 days and 18 hours.
Fan slot 3 : total : 3 days and 6 hours.
critical : 0 days and 18 hours.
NIF slot 1 : notconnect
NIF slot 2 : total : 1 days and 0 hours.
critical : 0 days and 0 hours.
NIF slot 3 : notconnect
NIF slot 4 : total : 2 days and 6 hours.
critical : 0 days and 18 hours.
> |
運用コマンドshow environmentのtemperature-loggingパラメータで温度履歴情報を確認できます。次の図に例を示します。
> show environment temperature-logging Date 20XX/12/10 20:00:00 UTC Date 0:00 6:00 12:00 18:00 20XX/12/10 - - 26.0 24.0 20XX/12/09 22.2 24.9 26.0 24.0 20XX/12/08 24.0 23.5 26.0 24.0 20XX/12/07 21.0 - 26.0 24.0 20XX/12/06 25.6 - 26.0 24.0 20XX/12/05 21.8 25.1 26.0 24.0 20XX/12/04 24.3 24.2 26.0 > |