コンフィグレーションガイド Vol.1

14.1.3　装置の状態確認

運用コマンドshow systemで装置の動作状態や搭載メモリ量などを確認できます。次の図に例を示します。

図14-2　装置の状態確認

> show system
Date 20XX/08/10 17:53:12 UTC
System: AX4630S-4M, OS-L3CA Ver. 11.14
Node : Name=
    Contact=
    Locate=
    Elapsed time : 00:45:03
    LED Brightness mode : normal
    Machine ID : 0012.e201.023a
    Power redundancy-mode : check is not executed
    Power slot 1 : active PS-M(AC)
        Fan  : active No = Fan1(1)  Speed = normal, Direction = F-to-R
        PS   : active
        Lamp : Power LED=green , ALM1 LED=light off 
    Power slot 2 : active PS-M(DC)
        Fan  : active No = Fan1(1)  Speed = normal, Direction = F-to-R
        PS   : active
        Lamp : Power LED=green , ALM1 LED=light off
    Fan slot 1 : active FAN-M
        Fan  : active No = Fan3(1)  Speed = normal, Direction = F-to-R
    Fan slot 2 : active FAN-M
        Fan  : active No = Fan4(1)  Speed = normal, Direction = F-to-R
    Fan slot 3 : active FAN-M
        Fan  : active No = Fan5(1)  Speed = normal, Direction = F-to-R
    Main board : active
        Boot : 20XX/08/10 17:08:19 , operation reboot
        Fatal restart : CPU 0 times ,  SW 0 times
        Lamp : Power LED=green , Status LED1=green
        Board : CPU=PowerPC 1200MHz , Memory=2,097,152kB(2048MB)
        Management port: active up
             1000BASE-T full(auto) 0012.e238.3401
        Temperature : normal(26degree)
        Flash :
                  user area   config area     dump area    area total
            used  242,341kB         324kB           0kB     242,665kB
            free  168,787kB     241,081kB     130,798kB     540,666kB
            total 411,128kB     241,405kB     130,798kB     783,331kB
        MC  : enabled
            Manufacture ID : 00000003
            259,176kB used
            1,671,616kB free
            1,930,792kB total
        System traffic-mode : wire rate
            0/1 : disable   NIF3 : notconnect
            0/2 : disable   NIF4 : enable
            0/3 :  enable   NIF1 : notconnect
            0/4 :  enable   NIF2 : 2/21-24 disable
 
    Device resources
        Current selected swrt_table_resource : l3switch-1
        Current selected swrt_multicast_table : Off
        Current selected unicast multipath number: 16
        IP routing entry :
            Unicast : current number=6 , max number=13312
            Multicast : current number=0 , max number=2048
            ARP : current number=0 , max number=45054
        IPv6 routing entry :
            Unicast : current number=0 , max number=0
            Multicast : current number=0 , max number=0
            NDP : current number=0 , max number=0
        Multipath table entry : current number=0 , max number=256
        MAC-Address table entry : current number=1 , max number=98304
        System Layer2 Table Mode : mode=0
        Flow detection mode : layer3-mirror-5
          Used resources for filter inbound(Used/Max)
                    MAC      IPv4      IPv6
                    n/a    0/ 512    0/ 512
          Used resources for QoS(Used/Max)
                    MAC      IPv4      IPv6
                    n/a    0/ 256       n/a
          Used resources for UPC(Used/Max)
                    MAC      IPv4      IPv6
                    n/a    0/ 256       n/a
          Used resources for Mirror inbound(Used/Max)
                    MAC      IPv4      IPv6
                 2/ 256    3/ 256    0/ 256
          Used resources for TCP/UDP port detection pattern
            Resources(Used/Max):  1/32
              Destination Port   Used
                100-200        :       -/  -/mirror
        Flow detection out mode : layer3-2-out
          Used resources for filter outbound(Used/Max)
                    MAC      IPv4      IPv6
                 0/ 256    2/ 256    0/ 256
        Flow action change
            cos                : enable
            arp discard class  : enable
            arp reply cos      : enable
>

運用コマンドshow environmentでファン，電源，温度の状態，累積稼働時間を確認できます。ファンの運転モードはコンフィグレーションコマンドsystem fan modeで設定できます。次の図に例を示します。

図14-3　装置の環境状態確認

> show environment
Date 20XX/08/10 17:41:42 UTC
Power slot 1 : PS-M(AC), Direction = F-to-R
Power slot 2 : PS-M(DC), Direction = F-to-R
Fan slot 1   : FAN-M, Direction = F-to-R
Fan slot 2   : FAN-M, Direction = F-to-R
Fan slot 3   : FAN-M, Direction = F-to-R
 
Fan environment
    Power slot 1 : Fan1(1) = active
                   Speed = normal
    Power slot 2 : Fan2(1) = active
                   Speed = normal
    Fan slot 1   : Fan3(1) = active
                   Speed = normal
    Fan slot 2   : Fan4(1) = active
                   Speed = normal
    Fan slot 3   : Fan5(1) = active
                   Speed = normal
    Fan mode     : 1 (silent)
 
Power environment
    Power slot 1 : active
    Power slot 2 : active
 
Temperature environment
    Main  :  27 degrees C
    NIF1  : notconnect
    NIF2  :  30 degrees C
    NIF3  : notconnect
    NIF4  :  33 degrees C
    Warning level : normal
 
Accumulated running time
    Main         :  total    : 20 days and 0 hours.
                    critical : 0 days and 0 hours..
    Power slot 1 :  total    : 10 days and 12 hours.
                    critical : 0 days and 0 hours.
    Power slot 2 :  total    : 9 days and 23 hours.
                    critical : 0 days and 0 hours.
    Fan slot 1   :  total    : 3 days and 6 hours.
                    critical : 0 days and 18 hours.
    Fan slot 2   :  total    : 3 days and 6 hours.
                    critical : 0 days and 18 hours.
    Fan slot 3   :  total    : 3 days and 6 hours.
                    critical : 0 days and 18 hours.
    NIF slot 1   : notconnect
    NIF slot 2   :  total    : 1 days and 0 hours.
                    critical : 0 days and 0 hours.
    NIF slot 3   : notconnect
    NIF slot 4   :  total    : 2 days and 6 hours.
                    critical : 0 days and 18 hours.
>

運用コマンドshow environmentのtemperature-loggingパラメータで温度履歴情報を確認できます。次の図に例を示します。

図14-4　温度履歴情報の確認

> show environment temperature-logging
Date 20XX/12/10 20:00:00 UTC
Date         0:00  6:00 12:00 18:00
20XX/12/10      -     -  26.0  24.0
20XX/12/09   22.2  24.9  26.0  24.0
20XX/12/08   24.0  23.5  26.0  24.0
20XX/12/07   21.0     -  26.0  24.0
20XX/12/06   25.6     -  26.0  24.0
20XX/12/05   21.8  25.1  26.0  24.0
20XX/12/04   24.3  24.2  26.0
>

[目次][前へ][次へ]

[他社商品名称に関する表示]

14.1.3 装置の状態確認

14.1.3　装置の状態確認