45.1.7 装置の管理情報
メッセージ |
内容 |
---|---|
Cannot change the switch model. |
装置のモデルは変更できません。 |
Cannot configure switch <switch no.> provision configuration because stack is active. |
指定したスイッチ番号はスタックで動作しているので実行できません。 スイッチ番号を確認してください。 |
<switch no.>:スイッチ番号 |
|
Can't delete this command, because stack relation configuration specified. |
スタック関連のコンフィグレーションが指定されているので,このコマンドを削除できません。 スタック関連のコンフィグレーションを削除してください。 |
Can't edit the configuration, because stack enable configuration specified. |
stack enableを指定しているため,コンフィグレーションの編集はできません。 装置再起動後にコンフィグレーションを設定してください。 |
stack enable is necessary for this command. |
このコマンドの設定には,stack enableコマンドが必要です。 stack enableコマンドを設定してから,本コマンドを設定してください。 |
The system interface hundredgigabitethernet cannot be set because specified switch model does not support system interface hundredgigabitethernet. |
指定したスイッチのモデルはsystem interface hundredgigabitethernetコンフィグレーションをサポートしていないため,設定できません。 |
This command cannot be set because it will disable the interface used by 'monitor session' |
system interface hundredgigabitethernetコマンド設定時に無効になるインタフェースが,monitor sessionコマンドによって設定されています。 monitor sessionコマンドの設定を削除してから,再度実施してください。 |