コンフィグレーションコマンドレファレンス Vol.1

[目次][索引][前へ][次へ]


40.1.17 IEEE802.1X情報

表40-17 IEEE802.1Xのエラーメッセージ

メッセージ 内容
ChGr <channel group number>: Inconsistency is found between the dot1x port-control and the dot1x vlan <vlan id> enable configuration. VLAN単位認証(静的)のVLANとポート単位認証のチャネルグループとの関係が不一致です。
VLAN単位認証(静的)を設定したVLANに所属しているチャネルグループにポート単位認証は設定できません。
ポート単位認証を設定したチャネルグループが所属しているVLANにVLAN単位認証(静的)は設定できません。
<channel group number>:チャネルグループ番号
<vlan id>:VLAN ID
ChGr <channel group number>: Inconsistency is found between the dot1x port-control and the switchport mode configuration. ポート単位認証のチャネルグループとレイヤ2インタフェース属性との関係が不一致です。
ポート単位認証を設定したチャネルグループにswitchport modeでアクセスモード以外のモードは設定できません。
switchport modeでアクセスモード以外のモードを設定したチャネルグループにポート単位認証は設定できません。
<channel group number>:チャネルグループ番号
ChGr <channel group number>: Inconsistency is found between the reauthentication and the ignore-eapol-start configuration. ポート単位認証のチャネルグループのignore-eapol-startとreauthenticationとの関係が不一致です。
reauthenticationが設定されていない場合,ignore-eapol-startは設定できません。
reauthenticationを設定したあとでignore-eapol-startを設定してください。
<channel group number>:チャネルグループ番号
ChGr <channel group number>: Inconsistency is found between the supplicant-detection and the ignore-eapol-start configuration. ポート単位認証のチャネルグループのignore-eapol-startとsupplicant-detectionとの関係が不一致です。
ignore-eapol-startが設定されている場合,supplicant-detectionにdisableを設定できません。
supplicant-detectionにdisableが設定されている場合,ignore-eapol-startは設定できません。
<channel group number>:チャネルグループ番号
Inconsistency is found between IGMP snooping and the dot1x multiple-authentication configuration. IGMP snoopingと新規端末検出モードがautoのポート単位認証との関係が不一致です。
IGMP snoopingと新規端末検出モードがautoのポート単位認証は同時に設定できません。
Inconsistency is found between IGMP snooping and the dot1x vlan <vlan id> supplicant-detection auto configuration. IGMP snoopingと新規端末検出モードがautoのVLAN単位認証(静的)のコンフィグレーションとの関係が不一致です。
IGMP snoopingと新規端末検出モードがautoのVLAN単位認証(静的)は同時に設定できません。
<vlan id>:VLAN ID
Inconsistency is found between IGMP snooping and the dot1x vlan dynamic supplicant-detection auto configuration. IGMP snoopingと新規端末検出モードがautoのVLAN単位認証(動的)との関係が不一致です。
IGMP snoopingと新規端末検出モードがautoのVLAN単位認証(動的)は同時に設定できません。
Inconsistency is found between the dot1x and the fense configuration. IEEE802.1Xコンフィグレーションと認証VLANコンフィグレーションとの関係が不一致です。
dot1x system-auth-controlは,次のどれかと同時に設定できません。
  • fense vaa-name
  • fense vlan
  • fense server
Inconsistency is found between the dot1x and the gsrp configuration. IEEE802.1XコンフィグレーションとGSRPコンフィグレーションとの関係が不一致です。
dot1x system-auth-controlとgsrpを同時に設定できません。
Inconsistency is found between the dot1x configuration and the l2protocol-tunnel eap configuration. IEEE802.1XコンフィグレーションとEAPOLフォワーディングコンフィグレーションとの関係が不一致です。
dot1x system-auth-controlとl2protocol-tunnel eapを同時に設定できません。
Inconsistency is found between the dot1x vlan enable or dot1x vlan dynamic radius-vlan <vlan id> and the vlan configuration. VLAN単位認証(静的)またはVLAN単位認証(動的)のVLANとVLANコンフィグレーションとの関係が不一致です。
VLAN単位認証(静的)またはVLAN単位認証(動的)が設定されているVLANを削除できません。
VLAN単位認証(静的)またはVLAN単位認証(動的)のVLANの設定を削除したあとで,VLANを削除してください。
<vlan id>:VLAN ID
port <nif no.>/<port no.>: Inconsistency is found between the dot1x port-control and the dot1x vlan <vlan id> enable configuration. VLAN単位認証(静的)のVLANとポート単位認証のポートとの関係が不一致です。
VLAN単位認証(静的)を設定したVLANに所属しているポートにポート単位認証は設定できません。
ポート単位認証を設定したポートが所属しているVLANにVLAN単位認証(静的)は設定できません。
<nif no.>/<port no.>:NIF番号/ポート番号
<vlan id>:VLAN ID
port <nif no.>/<port no.>: Inconsistency is found between the dot1x port-control and the switchport mode configuration. ポート単位認証のポートとレイヤ2インタフェース属性との関係が不一致です。
ポート単位認証を設定したポートにswitchport modeでアクセスモード以外のモードは設定できません。
switchport modeでアクセスモード以外のモードを設定したポートにポート単位認証は設定できません。
<nif no.>/<port no.>:NIF番号/ポート番号
port <nif no.>/<port no.>: Inconsistency is found between the reauthentication and the ignore-eapol-start configuration. ポート単位認証のポートのignore-eapol-startとreauthenticationとの関係が不一致です。
reauthenticationが設定されていない場合,ignore-eapol-startは設定できません。
reauthenticationを設定したあとでignore-eapol-startを設定してください。
<nif no.>/<port no.>:NIF番号/ポート番号
port <nif no.>/<port no.>: Inconsistency is found between the supplicant-detection and the ignore-eapol-start configuration. ポート単位認証のポートのignore-eapol-startとsupplicant-detectionとの関係が不一致です。
ignore-eapol-startが設定されている場合,supplicant-detectionにdisableを設定できません。
supplicant-detectionにdisableが設定されている場合,ignore-eapol-startは設定できません。
<nif no.>/<port no.>:NIF番号/ポート番号
The total count of dot1x vlan definitions is beyond the maximum value (1024). VLAN単位認証(静的,動的)を設定したVLANの合計が上限を超えています。
上限(1024)の範囲で設定してください。
The total count of dot1x vlan ports and port-channel combined is beyond the maximum value (1024). VLAN単位認証(静的,動的)を設定したVLANに所属するポートとチャネルグループの合計が上限を超えています。
上限(1024)の範囲で設定してください。
vlan <vlan id>: Inconsistency is found between the dot1x vlan enable and the switchport configuration. VLAN単位認証(静的)のVLANとプロトコルVLANポートまたはMAC VLANポートとの関係が不一致です。
VLAN単位認証(静的)を設定したVLANにswitchport protocol-vlanでプロトコルVLANのネイティブVLANまたはswitchport mac-vlanでMAC VLANのネイティブVLANは設定できません。
switchport protocol-vlanでプロトコルVLANのネイティブVLAN,またはswitchport mac-vlanでMAC VLANのネイティブVLANを設定したVLANにVLAN単位認証(静的)は設定できません。
<vlan id>:VLAN ID
vlan <vlan id>: Inconsistency is found between the dot1x vlan enable and the vlan configuration. VLAN単位認証(静的)のVLANとVLANコンフィグレーションとの関係が不一致です。
VLAN単位認証(静的)のVLANに指定したVLANにvlanコマンドでポートVLANが設定されていません。
vlanコマンドでポートVLANを設定したVLANをVLAN単位認証(静的)のVLANに指定してください。
<vlan id>:VLAN ID
vlan <vlan id>: Inconsistency is found between the reauthentication and the ignore-eapol-start configuration. VLAN単位認証(静的)のVLANのignore-eapol-startとreauthenticationとの関係が不一致です。
reauthenticationが設定されていない場合,ignore-eapol-startは設定できません。
reauthenticationを設定したあとでignore-eapol-startを設定してください。
<vlan id>:VLAN ID
vlan <vlan id>: Inconsistency is found between the supplicant-detection and the ignore-eapol-start configuration. VLAN単位認証(静的)のVLANのignore-eapol-startとsupplicant-detectionとの関係が不一致です。
ignore-eapol-startが設定されている場合,supplicant-detectionにdisableを設定できません。
supplicant-detectionにdisableが設定されている場合,ignore-eapol-startは設定できません。
<vlan id>:VLAN ID
vlan dynamic: Inconsistency is found between the radius-vlan <vlan id> and the vlan configuration. VLAN単位認証(動的)のVLANとVLANコンフィグレーションとの関係が不一致です。
VLAN単位認証(動的)のVLANに指定したVLANにvlanコマンドでMAC VLANが設定されていません。
vlanコマンドでMAC VLANを設定したVLANをVLAN単位認証(動的)のVLANに指定してください。
<vlan id>:VLAN ID
vlan dynamic: Inconsistency is found between the reauthentication and the ignore-eapol-start configuration. VLAN単位認証(動的)のignore-eapol-startとreauthenticationとの関係が不一致です。
reauthenticationが設定されていない場合,ignore-eapol-startは設定できません。
reauthenticationを設定したあとでignore-eapol-startを設定してください。
vlan dynamic: Inconsistency is found between the supplicant-detection and the ignore-eapol-start configuration. VLAN単位認証(動的)のignore-eapol-startとsupplicant-detectionとの関係が不一致です。
ignore-eapol-startが設定されている場合,supplicant-detectionにdisableを設定できません。
supplicant-detectionにdisableが設定されている場合,ignore-eapol-startは設定できません。

[目次][前へ][次へ]


[他社商品名称に関する表示]

All Rights Reserved, Copyright(C), 2005, 2012, ALAXALA Networks, Corp.