運用コマンドレファレンス Vol.2
[機能]
NAT-PTに関するログを削除します。
[入力形式]
clear ipv6 natpt log [ bind ]
[パラメータ]
- bind
- 運用ログを削除します。
- 省略
- 標準ログを削除します。
[使用者レベル]
一般ユーザ
[実行例]
図2-48 clear ipv6 natpt log表示画面
> show ipv6 natpt log Date Time Log Detail Protocol Ipv6 Address IPv4 Address 05/31 14:16:35 Add - TCP CLOSED FEDC:4501:100C:5310:2A04:24FF:FE48:7A3C 50821 132.146.243.30 1027 05/31 14:16:32 Fail6->4 FAIL_TCP_STATUS_WRONG TCP CLOSED FEDC:4501:100C:5310:2A04:24FF:FE48:7A3C 50821 ---> 132.146.243.30 80 > > clear ipv6 natpt log > > show ipv6 natpt log No entry. > > show ipv6 natpt log bind Date Time Log Detail Protocol Ipv6 Address IPv4 Address 05/31 14:16:35 Add - TCP CLOSED FEDC:4501:100C:5310:2A04:24FF:FE48:7A3C 50821 132.146.243.30 1027 > > clear ipv6 natpt log bind > > show ipv6 natpt log bind No entry. >
[ユーザ通信への影響]
なし
[応答メッセージ]
表2-50 clear ipv6 natpt logコマンド応答メッセージ
メッセージ 内容 NAT-PT not active. NAT-PTの構成定義が設定されていないか,無効設定されています。 natpt: clearLog(): soctl failure: errno情報 コマンド送信が失敗しました。
[注意事項]
なし
Copyright (c)2005 ALAXALA Networks Corporation. All rights reserved.