構成定義コマンドレファレンス Vol.2
表12-12 VRRP情報のエラーメッセージ
メッセージ 内容 Check status interval is not in range of 1 to 255. check status intervalが範囲外です。
1〜255の間で指定してください。Check trial times is not in range of 1 to 10. check trial timesが範囲外です。
1〜10の間で指定してください。Critical interface with target address not specified. critical interfaceが設定されていません。
target addressを設定するにはcritical interfaceを設定してください。Down priority is not in range of 1 to 255. down priorityが範囲外です。
1〜255の間で指定してください。Failure detection interval is not in range of 1 to 255. failure detection intervalが範囲外です。
1〜255の間で指定してください。Failure detection times is greater than check trial times. failure detection timesがcheck trial timesを超えています。
check trial times以下の値を設定してください。Failure detection times is not in range of 1 to 10. failure detection timesが範囲外です。
1〜10の間で指定してください。Master transition delay is not in range of 1 to 65535. master transition delayが範囲外です。
1〜65535の間で指定してください。Recovery detection interval is not in range of 1 to 255. recovery detection intervalが範囲外です。
1〜255の間で指定してください。Recovery detection times is greater than check trial times. recovery detection timesがcheck trial timesを超えています。
check trial times以下の値を設定してください。Recovery detection times is not in range of 1 to 10. recovery detection timesが範囲外です。
1〜10の間で指定してください。Target address not specified. target addressが設定されていません。
target addressを設定してください。
Copyright (c)2005 ALAXALA Networks Corporation. All rights reserved.