35.2.1 List of configuration commands
The following table lists the commands used to configure network partitions.
|
Command name |
Description |
|---|---|
|
ipv6 maximum routes |
Sets the maximum-number-of-routes-for-the-IPv6 of VRF and the threshold-for-warning-output-messages. |
|
maximum routes |
Sets the maximum-number-of-routes-for-the-IPv4 of VRF and the threshold-for-warning-output-messages. |
|
vrf definition |
Configures a VRF. |
|
arp-limit #1 |
Sets the maximum number of ARP entries for VRF. |
|
vrf forwarding #1 |
Specify VRF for the interfaces. |
|
nd-limit #2 |
Sets the maximum number of NDP entries for VRF. |
- Note #1
-
See "Configuration Command Reference Vol.2" "2 IPv4 .ARP .ICMP".
- Note #2
-
See "Configuration Command Reference Vol.2" "17 IPv6 .NDP .ICMPv6".