33.2.1 List of configuration commands
The following tables list the commands used to configure IPv6 multicast route filtering.
Command name |
Description |
---|---|
ipv6 access-list #1 |
Configures an access list that acts as a IPv6 address filter. |
match ipv6 address #2 |
Configure filtering criteria by IPv6 destination address in route-map. |
match vrf #2 |
Configures route-map to use a VRF as filter conditions. |
ipv6 import multicast inter-vrf #3 |
Controls IPv6 multicast forwarding requests from other VRF or globalnetworks according to filters. |
- Note #1
-
See Configuration Command Reference Vol.1" "25 Access List.
- Note #2
-
See "Configuration Command Reference Vol.2" "15 Route Filtering (Common to IPv4/IPv6)".
- Note #3
-
See "Configuration Command Reference Vol.2" "32 VRF".