29.3.1 List of operation commands
The following table lists the operation commands related to the basic functions.
Command name |
Description |
---|---|
show ipv6 route |
Displays routing information stored in the routing table. |
clear ipv6 route |
Clears the IPv6 forwarding entries stored in the Switch and re-registers the routing entries. |
show ipv6 bgp |
Shows information about the BGP4+ protocol. |
clear ipv6 bgp |
Clears BGP4+ sessions or BGP4+-related information, or filters inbound or outbound routes using new BGP filter information. Also reconnects a BGP4+ session that was terminated because a peer exceeded the maximum number of BGP4+ routes that can be learned from a particular device. |
show ipv6 vrf |
Displays the IPv6 information for VRFs. |
show processes cpu unicast # |
Shows the CPU usage of a unicast routing program. |
restart unicast # |
Restarts the unicast routing program. |
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".