27.5.4 Checking interface information

You can use the show ipv6 ospf interface operation command to display information about interfaces running OSPFv3, including the interface name (Interface), state (State), priority (Priority), cost value (Cost), and the number of neighboring routers (Neighbor).

The command does not display information for IPv6 interfaces that are down.

Figure 27-10: Result of executing show ipv6 ospf interface command
>show ipv6 ospf interface Date 20XX/07/14 12:00:00 UTC Domain: 1 Area: 0 Interface State Priority Cost Neighbor VLAN0003 DR 1 1 1 Area: 1 Interface State Priority Cost Neighbor VLAN0004 BackupDR 10 20 10

Figure 27-10: Result of executing show ipv6 ospf interface command

>show ipv6 ospf interface
Date 20XX/07/14 12:00:00 UTC
Domain: 1
Area: 0
  Interface         State     Priority  Cost   Neighbor
  VLAN0003          DR           1      1      1
 
Area: 1
  Interface         State     Priority  Cost   Neighbor
  VLAN0004          BackupDR     10     20     10