27.4.1 List of configuration commands
The following tables list the commands used to configure OSPFv3 interfaces.
Command name |
Description |
---|---|
ipv6 ospf dead-interval |
Sets the length of time that the router maintains adjacency after receiving no hello packets from a neighboring router. |
ipv6 ospf hello-interval |
Sets the sending interval for hello packets. |
ipv6 ospf network |
Sets the interface type (broadcast or point-to-point). |
ipv6 ospf priority |
Sets the router priority which determines the designated router for the network. |
ipv6 ospf retransmit-interval |
Sets the time between link-state advertisement (LSA) retransmissions. |
ipv6 ospf transmit-delay |
Sets the time required to send an OSPFv3 packet. |
passive-interface (OSPFv3) |
Sets the interface to passive mode. |
The following table describes the configuration commands related to OSPFv3 operation.
Command name |
Description |
---|---|
system mtu #1 |
Sets the MTU of the switch. |
ip mtu #2 |
Specifies the MTU length of IP packets sent on the interface. |
interface loopback #3 |
Sets the loopback interface (used as a passive interface in OSPFv3). |
- Note #1
-
See "Configuration Command Reference Vol.1" "15 : Ethernet".
- Note #2
-
See "Configuration Command Reference Vol.2" "2 IPv4 .ARP .ICMP".
- Note #3
-
See Configuration Command Reference Vol.2" "3 Loopback Interface (IPv4).