26.3.1 List of operation commands
The following describes the operation commands used to check RIPng.
Command name |
Description |
---|---|
show ipv6 route |
Displays routing information stored in the routing table. |
clear ipv6 route |
Clears the IPv6 forwarding entries stored in the Switch and re-registers the routing entries. |
show ipv6 rip |
Shows information about the RIPng protocol. |
clear counters rip ipv6-unicast |
Clears information about the RIPng protocol. |
show ipv6 vrf |
Displays the IPv6 information for VRFs. |
show ipv6 interface ipv6-unicast |
Shows information about the IPv6 interfaces on the Switch recognized by the unicast routing program. |
debug ipv6 |
Shows the packets being routed by IPv6 routing protocols in real time. |
show processes cpu unicast # |
Shows the CPU usage of a unicast routing program. |
debug protocols unicast # |
Starts the operation message display for event log information output by a unicast routing program. |
no debug protocols unicast # |
Stops the operation message display for event log information output by a unicast routing program. |
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".