26.2.1 List of configuration commands
The following tables list RIPng configuration commands.
Command name |
Description |
---|---|
default-metric |
Specifies the metric to be used when routing information learned by another protocol is advertised by RIPng. |
disable |
Disables RIPng. |
distance |
Specifies the distance for routing information learned by RIPng. |
generate-secondary-route |
Registers a secondary route in the routing table. |
inherit-metric |
Specifies that the metric is to be inherited when routing information learned by another routing protocol is advertised by RIPng. |
ipv6 rip enable |
Sends and receives RIPng packets via a specific interface. |
ipv6 rip metric-offset |
Specifies the metric increment when RIPng packets are sent or received via a specific interface. |
ipv6 router rip |
Configures RIPng-related operation information. |
passive-interface |
Disables a specified interface from sending routing information in RIPng packets. |
timers basic |
Specifies the values of the various RIPng timers. |
distribute-list in (RIPng) # |
Filters which RIPng-learned routes are added to the routing table. |
distribute-list out (RIPng) # |
Filters which RIPng routes are advertised. |
ipv6 prefix-list # |
Configures an IPv6 prefix list. |
redistribute (RIPng) # |
Specifies the protocol for routes advertised by RIPng. |
route-map # |
Configures route-map. |
- #
-
See "Configuration Command Reference Vol.2" "15 Route Filtering (Common to IPv4/IPv6)".