25.3.1 List of operation commands
The following tables list static routing (IPv6) operation commands.
Command name |
Description |
---|---|
show ipv6 route |
Displays routing information stored in the routing table. |
clear ipv6 route |
Clears the IPv6 forwarding entries stored in the Switch and re-registers the routing entries. |
show ipv6 static |
Shows information related to a static route. |
clear ipv6 static-gateway |
Performs polling for the gateways on the routes that were disabled by dynamic monitoring of static routes, and generates routes if the gateway responded. |
show ipv6 vrf |
Displays the IPv6 information for VRFs. |
show ipv6 interface ipv6-unicast |
Shows information about the IPv6 interfaces on the Switch recognized by the unicast routing program. |
restart unicast # |
Restarts the unicast routing program. |
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".