24.6.1 Checking the status of multipaths handled by the Switch

You can use show system command to check the multipath status handled by the Switch.

Figure 24-4: Checking the multipath status handled by the Switch
>show system : : Device resources Current selected swrt_table_resource: l3switch-2 Current selected swrt_multicast_table: On Current selected unicast multipath number: 8 : Multipath table entry: current number=1 , max number=512 MAC-Address table entry : current number=7 , max number=32768 : >

Figure 24-4: Checking the multipath status handled by the Switch

>show system
           :
           :
    Device resources
        Current selected swrt_table_resource: l3switch-2
        Current selected swrt_multicast_table: On
        Current selected unicast multipath number: 8
           :
        Multipath table entry: current number=1  , max number=512
        MAC-Address table entry : current number=7 , max number=32768
           :
>