24.5.1 List of configuration commands
The following table lists the commands used to configure load balancing.
Command name |
Description |
---|---|
maximum-paths (BGP4+) #1 |
Generates multipaths using the specified value as the maximum number of paths when multiple routing information entries of equal cost to a given destination exist. |
ipv6 route static maximum-paths #2 |
Specifies the maximum number of paths (maximum number of next hops) that the routing protocol will generate for a static IPv6 route. |
maximum-paths (OSPFv3) #3 |
Specifies the maximum number of paths in the route when multipaths (next hop) of equal cost exist for an OSPFv3-generated route. |
- Note #1
-
See "Configuration Command Reference Vol.2" "14 BGP4".
- Note #2
-
See Configuration Command Reference Vol.2" "25 Static Routing (IPv6).
- Note #3
-
See "Configuration Command Reference Vol.2" "27 OSPFv3".