17.2.1 List of configuration commands
The following tables list the commands used to configure IPv4 multicast route filtering.
|
Command name |
Description |
|---|---|
|
access-list #1 |
Sets an access list used as an IPv4 filter. |
|
ip access-list standard #1 |
Configures an access list to serve as an IPv4 address filter. |
|
match ip address #2 |
Configures route-map to use the IPv4 address prefix as filter conditions. |
|
match vrf #2 |
Configures route-map to use a VRF as filter conditions. |
|
import multicast inter-vrf #3 |
Controls IPv4 multicast forwarding requests from other VRF or globalnetworks according to filters. |
- Note #1
-
See Configuration Command Reference Vol.1" "25 Access List.
- Note #2
-
See "Configuration Command Reference Vol.2" "15 Route Filtering (Common to IPv4/IPv6)".
- Note #3
-
See "Configuration Command Reference Vol.2" "32 VRF".