13.3.1 List of operation commands

The following table lists the operation commands related to the basic functions.

Table 13-6: List of operation commands
Command name	Description
show ip route	Displays routing information stored in the routing table.
clear ip route	Clears the IPv4 forwarding entries and re-registers the routing entries.
show ip bgp	Shows information related to the BGP4 protocol.
clear ip bgp	Clears BGP4 sessions or BGP4-related information, or filters inbound or outbound routes using new BGP filter information. Also reconnects a BGP4 session that was terminated because a peer exceeded the maximum number of BGP4 routes that can be learned from a particular device.
show ip vrf	Displays IPv4 information in VRFs.
show processes cpu unicast^#	Shows the CPU usage of a unicast routing program.
restart unicast^#	Restarts the unicast routing program.
dump protocols unicast^#	Outputs the trace information and control table information collected by the unicast routing program to a file.
erase protocol-dump unicast^#	Deletes the file of trace information and control table information generated by the unicast routing program.

#: See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".