11.5.1 List of operation commands
The following tables list the operation commands for OSPF.
Command name |
Description |
---|---|
show ip route |
Shows the entries in the routing table. |
clear ip route |
Clears the IPv4 forwarding entries and re-registers the routing entries. |
show ip ospf |
Shows OSPFv3 information such as the domain number, information about neighboring routers, interface information, and LSAs. |
clear ip ospf |
Clears information about the OSPF protocol. |
show ip vrf |
Displays IPv4 information in VRFs. |
show ip interface ipv4-unicast |
Shows information about the IPv4 interfaces on the Switch recognized by the unicast routing program. |
debug ip |
Shows the packets being routed by IPv4 routing protocols in real time. |
show processes cpu unicast # |
Shows the CPU usage of a unicast routing program. |
restart unicast # |
Restarts the unicast routing program. |
debug protocols unicast # |
Starts the operation message display for event log information output by a unicast routing program. |
no debug protocols unicast # |
Stops the operation message display for event log information output by a unicast routing program. |
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".