9.3.1 List of operation commands
The following tables list static routing (IPv4) operation commands.
|
Command name |
Description |
|---|---|
|
show ip route |
Displays routing information stored in the routing table. |
|
clear ip route |
Clears the IPv4 forwarding entries and re-registers the routing entries. |
|
show ip static |
Shows information related to a static route. |
|
clear ip static-gateway |
Performs polling for the gateways on the routes that were disabled by dynamic monitoring of static routes, and generates routes if the gateway responded. |
|
show ip vrf |
Displays IPv4 information in VRFs. |
|
show ip interface ipv4-unicast |
Shows information about the IPv4 interfaces on the Switch recognized by the unicast routing program. |
|
restart unicast # |
Restarts the unicast routing program. |
|
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
|
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".