8.5.1 List of configuration commands
The following table lists the commands used to configure load balancing.
Command name |
Description |
---|---|
ip route static maximum-paths #1 |
Specifies the maximum number of paths (maximum number of next hops) that the routing protocol will generate for a static IPv4 route. |
maximum-paths (OSPF) #2 |
Specifies the maximum number of paths in the route when multiple paths (next hops) of equal cost exist for an OSPF-generated route. |
maximum-paths (BGP4) #3 |
Generates multipaths using the specified value as the maximum number of paths when multiple routing information entries of equal cost to a given destination exist. |
- #1
-
See Configuration Command Reference Vol.2" "11 Static Routing (IPv4).
- #2
-
See "Configuration Command Reference Vol.2" "13 OSPF".
- #3
-
See "Configuration Command Reference Vol.2" "14 BGP4".