4.2.1 List of configuration commands
The following table lists the commands used to configure policy-based routing.
|
Command name |
Description |
|---|---|
|
default |
Sets the default operation for policy-based routing list information. |
|
policy-interface |
Sets a route in policy-based routing list information. |
|
policy-list |
Sets policy-based routing list information. |
|
policy-list default-aging-interval |
Sets the period during which monitoring of the forwarding availability of policy-based routing is stopped when the master switch is switched in a stacked configuration. |
|
policy-list default-init-interval |
Sets the interval during which the following monitoring is stopped: the monitoring of whether the forwarding of policy-based routing (for example, during startup of a device) is possible. |
|
policy-list resequence |
Resets the value that controls the sequence in which policy-based routing routes are applied. |
|
recover |
Sets the path switch-back operation for policy-based routing list information. |
|
access-list # |
Sets an access list used as an IPv4 filter. |
|
ip access-group # |
Applies an IPv4 filter to a VLAN interface, and enables IPv4 filter functionality. |
|
ip access-list extended # |
Sets an access list used as an IPv4 packet filter. |
|
permit # |
Specifies conditions by which a filter permits access. |
- #
-
See Configuration Command Reference Vol.1" "25 Access List.
The following table describes the commands used to configure the policy-based routing tracking functionality.
|
Command name |
Description |
|---|---|
|
default-state |
Sets the default track state. |
|
disable |
Stops track operation. |
|
failure detection |
Sets the number of times polling is performed and the polling interval during failure verification. |
|
interval |
Sets the polling interval. |
|
recovery detection |
Sets the number of times polling is performed and the polling interval during failure recovery verification. |
|
timeout |
Sets the polling response wait time. |
|
track-object |
Sets tracks for the tracking functionality. |
|
track-object default-aging-interval |
Sets the period during which the tracking functionality of policy-based routing temporarily stops monitoring when the master switch is switched in a stacked configuration. |
|
track-object default-init-interval |
Sets the period until monitoring by the tracking function of policy-based routing is started at the startup of the switch. |
|
type icmp |
Sets IPv4 ICMP polling monitoring as the track type. |