25.3.2 Viewing OADP Info
OADP information can be displayed by using the show oadp operation command. The show oadp command displays the OADP settings and basic information for each port. The show oadp detail command displays detailed information about neighboring devices.
> show oadp
Date 20XX/11/09 19:50:20 UTC
OADP/CDP status: Enabled/Disabled Device ID: OADP-1
Interval Time: 60 Hold Time: 180
ignore vlan: 2-4,10
Enabled Port: 0/1-5,16,20
CH 10
Total Neighbor Counts=2
Local VID Holdtime Remote VID Device ID Capability Platform
0/1 0 35 0/8 0 OADP-2 RS AX3640S-24TW
0/16 0 9 0/1 0 OADP-3 S AX2430S-48T
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
> |
> show oadp detail
Date 20XX/11/09 19:55:52 UTC
OADP/CDP status: Enabled/Disabled Device ID: OADP-1
Interval Time: 60 Hold Time: 180
ignore vlan: 2-4,10
Enabled Port: 0/1-5,16,20
Total Neighbor Counts=2
---------------------------------------------------------
Port: 0/1 VLAN ID: 0
Holdtime : 6(sec)
Port ID : 0/8 VLAN ID(TLV): 0
Device ID : OADP-2
Capabilities : Router, Switch
Platform : AX3640S-24TW
Entry address(es):
IP address : 192.16.170.87
IPv6 address: fe80::200:4cff:fe71:5d1c
IfSpeed : 1G Duplex : FULL
Version : ALAXALA AX3640S AX-3640-24TW-A [AX3640S-24TW] Switching software Ver. 11.6 [OS-L3A]
---------------------------------------------------------
Port: 0/16 VLAN ID: 0
Holdtime : 10(sec)
Port ID : 0/1 VLAN ID(TLV): 0
Device ID : OADP-3
Capabilities : Switch
Platform : AX2430S-48T
Entry address(es):
IP address : 192.16.170.100
IfSpeed : 1G Duplex : FULL
Version : ALAXALA AX2430S AX-2430S-48T [AX2430S-48T] Switching software Ver. 11.6 [OS-L2]
---------------------------------------------------------
> |