24.2.1 List of configuration commands
The following tables list LLDP configuration commands.
Command name |
Description |
---|---|
lldp enable |
Enables operation of LLDP for a port. |
lldp hold-count |
Specifies how long the LLDP frames sent from the Switch to neighboring devices will be retained on the neighboring devices. |
lldp interval-time |
Specifies the interval at which the Switch sends LLDP frames. |
lldp management-address |
Set the administrative adress of Management Address TLV to be sent. |
lldp run |
Enables LLDP for the entire device. |