20.2.1 List of configuration commands
The following table lists the commands used to configure policy-based mirroring.
Command name |
Description |
---|---|
destination session |
Sets the mirror port for policy-based mirroring. |
destination-interface-list |
Sets the destination interface list for policy-based mirroring. |
flow detection mode #1 |
Sets the flow detection mode of the receiving side. |
ip access-group #2 |
Applies IPv4 packet filtering to the interface to detect the frames subject to policy-based mirroring. |
ip access-list extended #2 |
Configures an access list that detects frames subject to policy-based mirroring by IPv4 packet filtering. |
ipv6 access-list #2 |
Configures an access list that detects frames subject to policy-based mirroring by IPv6 filtering. |
ipv6 traffic-filter #2 |
Applies IPv6 filters to interfaces that detect the frames for which policy-based mirroring is performed. |
mac access-group #2 |
Applies MAC filters to interfaces that detect the frames for which policy-based mirroring is performed. |
mac access-list extended #2 |
Configures an access list that detects frames subject to policy-based mirroring by MAC filtering. |
permit #2 |
Specify the flow detection conditions for detecting target packets and the destination interface list for mirroring target frames in the access list. |
- Note #1
-
See "Configuration command reference Vol.1" "24 flow detection mode/flow operation".
- Note #2
-
See Configuration Command Reference Vol.1" "25 Access List.