17.2.1 List of configuration commands
The following tables list the commands used to configure L2 loop-detection.
|
Command name |
Description |
|---|---|
|
loop-detection |
Sets the port type for the L2 loop detection functionality. |
|
loop-detection auto-restore-time |
Sets the time (in seconds) until a deactivated port is activated automatically. |
|
loop-detection enable |
Enables the L2 loop detection functionality. |
|
loop-detection hold-time |
Specifies the time (in seconds) that the number of received L2 loop detection frames is held before a port is changed to the inactive status. |
|
loop-detection interval-time |
Sets the interval for sending L2 loop detection frames. |
|
loop-detection threshold |
Sets the number of received L2 loop detection frames before a port is deactivated. |