16.1.2 Support Specifications
The following table describes the specifications supported for uplink redundancy.
Item |
Support or specified value |
||
---|---|---|---|
Standalone |
Stack |
||
Applicable interfaces |
Physical ports |
OK |
OK #1 |
Link Aggregation |
OK |
OK #1 #2 |
|
Number of uplink ports |
50 |
50 |
|
Number of interfaces that can be configured for one uplink port pair |
2 |
2 |
|
Automatic active-port switch-back to the primary port |
OK |
OK |
|
Suppression of automatic active-port switch-back to the primary port |
OK |
OK |
|
Command for changing the active port |
OK |
OK |
|
Flash Control Frame Transmission/Reception Function at Active Port Change |
OK |
OK |
|
MAC Address Update Function When Changing the Active Port |
OK |
OK |
|
Port Reset Function When Changing the Active Port |
OK |
OK |
|
Fixed Active Port Function at Startup |
OK |
OK #3 |
|
Private MIB, private SNMP notification |
OK |
OK |
Legend: OK: Supported
- Note #1
-
The primary and secondary ports cannot be set to the same member switch.
- Note #2
-
You cannot configure link aggregation across multiple member switches on a primary or secondary port.
- Note #3
-
This function is released when the master switch is switched.