15.2.1 List of configuration commands

vrrp accept

Enables accept mode.

vrrp authentication

Sets a password for authenticating advertisement packets.

vrrp follow

Specifies a primary virtual router and configures the virtual router as a follower virtual router.

vrrp ietf-ipv6-spec-07-mode

Sets an IPv6 virtual router to operate in the mode specified in draft-ietf-vrrp-ipv6-spec-07.

vrrp ip

vrrp ipv6

Configure a virtual IP address for the virtual router

vrrp name

Sets a name for the virtual router.

vrrp preempt

Enables automatic switch-back.

vrrp preempt delay

Sets a period of time for suppressing automatic switch-back.

vrrp priority

Sets the priority to a virtual router.

vrrp timers advertise

Sets the sending interval of advertisement packets to be sent by a virtual router.

vrrp timers non-preempt-swap

Sets the switch-back suppression time to be applied when switch-back processing is performed while automatic switch-back is suppressed.

track check-reply-interface

Sets whether to check if the sending and receiving interfaces for VRRP polling match.

track check-status-interval

Sets the normal VRRP polling interval.

track check-trial-times

Sets the normal count for VRRP polling.

track failure-detection-interval

Sets the VRRP polling interval to be applied during failure verification.

track failure-detection-times

Sets the count for VRRP polling to be performed during failure verification.

track interface

Sets an interface to be monitored for failures and the method for monitoring failures.

track ip route

Sets the destination for VRRP polling for a track.

track recovery-detection-interval

Sets the VRRP polling interval to be applied during failure recovery verification.

track recovery-detection-times

Sets the count for VRRP polling to be performed during failure recovery verification.

vrrp track

Sets a track for a virtual router.