14.1.5 Configuring GSRP VLAN group-only control functionality

Points to note

Enable the GSRP VLAN group-only control functionality. When this functionality is enabled, GSRP controls only the VLANs that belong to VLAN groups. The VLAN ports that do not belong to any VLAN group are always able to forward frames.

You can use the GSRP VLAN group-only control functionality for the following purposes:

• To make it easier for Layer 3 redundancy switching to provide a connection to the upstream network

• To use VLANs that do not belong to any GSRP VLAN group as VLANs that are not under GSRP control

• To remotely manage the Switches

Command examples

1. (config)# gsrp limit-control

   Enable the GSRP VLAN group-only control functionality.