14.1.1 List of configuration commands
The following tables list GSRP configuration commands.
|
Command name |
Description |
|---|---|
|
advertise-holdtime |
Sets the retention time for GSRP Advertise frames. |
|
advertise-interval |
Sets the sending interval for GSRP Advertise frames. |
|
backup-lock |
Enables backup locking. |
|
flush-request-count |
Sets the number of times that GSRP Flush request frames are sent. |
|
gsrp |
Enables GSRP. |
|
gsrp-vlan |
Configures a GSRP-managed VLAN. |
|
gsrp direct-link |
Configures a direct link. |
|
gsrp exception-port |
Configures a port not under GSRP control. |
|
gsrp limit-control |
Enable the GSRP VLAN group-only control functionality. |
|
gsrp no-flush-port |
Configures a port that does not send GSRP Flush request frames. |
|
gsrp reset-flush-port |
Configures a port on which port resetting is used. |
|
layer3-redundancy |
Enables Layer 3 redundancy switching. |
|
no-neighbor-to-master |
Sets the switchover method to be used when a switch is in the backup (neighbor unknown) state. |
|
port-up-delay |
Enables the prevention of repeated switchover when links are unstable. |
|
reset-flush-time |
Sets the length of the link-down time when port resetting is used. |
|
selection-pattern |
Sets the priority for selecting the master and backup switches. |
|
virtual-mac-learning-interval |
Sets the sending interval for frames for virtual MAC address learning. |
|
vlan-group disable |
Disables a VLAN group. The VLANs belonging to a disabled VLAN group stop sending and receiving traffic. |
|
vlan-group priority |
Configures the priority of a VLAN group. |
|
vlan-group vlan |
Assigns VLANs to a VLAN group. |