7.2.1 List of operation commands
The following lists the operation commands that check IEEE802.1X status.
|
Command name |
Description |
|---|---|
|
show dot1x |
Shows the status of each authentication unit and information about authenticated supplicants. |
|
show dot1x logging |
Shows the operation log messages output by the IEEE 802.1X software. |
|
show dot1x statistics |
Shows statistics about IEEE 802.1X authentication. |
|
clear dot1x auth-state |
Clears information related to authenticated terminals. |
|
clear dot1x logging |
Clears the operation log messages output by the IEEE 802.1X software. |
|
clear dot1x statistics |
Resets IEEE 802.1X-related statistics to 0. |
|
reauthenticate dot1x |
Re-authenticates the status of IEEE 802.1X authentication. |
|
restart dot1x |
Restarts the IEEE 802.1X program. |
|
dump protocols dot1x |
Outputs the control table information and statistics gathered by the IEEE 802.1X software to a file. |