2.3.1 List of configuration commands

ip qos-flow-group

Applies an IPv4 QoS flow list to an Ethernet interface or VLAN and enables IPv4 QoS control.

ip qos-flow-list

Sets the QoS flow list used for IPv4 QoS flow detection.

ip qos-flow-list resequence

Resets the sequence number for the order in which the conditions in the IPv4 QoS flow list are applied.

ipv6 qos-flow-group

Applies an IPv6 QoS flow list to an Ethernet interface or VLAN and enables IPv6 QoS control.

ipv6 qos-flow-list

Sets the QoS flow list used for IPv6 QoS flow detection.

ipv6 qos-flow-list resequence

Resets the sequence number for the order in which the conditions in the IPv6 QoS flow list are applied.

mac qos-flow-group

Applies a MAC QoS flow list to an Ethernet interface or VLAN and enables MAC QoS control.

mac qos-flow-list

Sets the QoS flow list used for MAC QoS flow detection.

mac qos-flow-list resequence

Resets the sequence number for the order in which the conditions in the MAC QoS flow list are applied.

qos

Sets the flow detection condition and operation to be performed in the QoS flow list.

qos-queue-group

Applies QoS queue list information to an Ethernet interface and enables the legacy shaper.

qos-queue-list

Sets the scheduling mode in QoS queue list information.

remark

Specifies supplementary information for QoS.

traffic-shape rate

Sets port bandwidth control for an Ethernet interface.

flow action-change arp-discard-class ^#

Changes the queuing priorities for ARP broadcast frames.

flow action-change arp-reply-cos ^#

Changes CoS for ARP reply broadcast frames.

flow action-change cos ^#

Sets the functionality for changing which frames are subject to priority determination of the QoS functionality.

flow detection mode ^#

Sets the receiving-side flow detection mode for the filter and QoS control.