27.7.1 List of configuration commands

The following table lists the commands used to configure Single Spanning Tree.

Table 27-13: List of configuration commands
Command name	Description
spanning-tree cost	Sets the default path cost value for each port.
spanning-tree pathcost method	Sets the default value for the margin of values used for path costs for a port.
spanning-tree port-priority	Sets the default value for the port priority for each port.
spanning-tree single	The example below shows how to start or stop Single Spanning Tree.
spanning-tree single cost	Sets the path cost value for Single Spanning Tree.
spanning-tree single forward-time	Sets the time required for port status transitions.
spanning-tree single hello-time	Sets the sending interval for BPDUs.
spanning-tree single max-age	Sets the maximum enabled time for sent BPDUs.
spanning-tree single pathcost method	Sets the margin of values used for path costs for Single Spanning Tree.
spanning-tree single port-priority	Sets the port priority for Single Spanning Tree.
spanning-tree single priority	Sets the bridge priority.
spanning-tree single transmission-limit	Sets the maximum number of BPDUs that can be sent per hello-time interval.