26.3.2 Checking VTEP peering

You can use show vxlan peers command to check VTEP peering data. Status displays the build status of VXLAN tunneling. If the route is multipathed, only Status,Nexthop,VRF is displayed for the second and subsequent routes.

Figure 26-13: Display VTEP Peering Information
> show vxlan peers Date 20XX/10/29 11:33:50 UTC VTEP ID: 1 Source IP: 1.1.1.1 Destination IP Status Nexthop VRF 30.10.1.8 Up 10.10.1.225 global 30.10.1.21 Down - - 110.100.100.100 Up 100.100.100.200 10 VTEP ID: 2 Source IP: 1.1.1.2 Destination IP Status Nexthop VRF 50.20.1.30 Up 20.20.1.214 20 >

Figure 26-13: Display VTEP Peering Information

> show vxlan peers
Date 20XX/10/29 11:33:50 UTC
VTEP ID: 1   Source IP: 1.1.1.1
  Destination IP   Status  Nexthop          VRF
  30.10.1.8        Up      10.10.1.225      global
  30.10.1.21       Down    -                -
  110.100.100.100  Up      100.100.100.200  10
VTEP ID: 2   Source IP: 1.1.1.2
  Destination IP   Status  Nexthop          VRF
  50.20.1.30       Up      20.20.1.214      20
>