26.2.1 List of configuration commands

The following tables list VXLAN configuration commands.

Table 26-5: List of configuration commands
Command name	Description
destination-ip	Configure the destination IPv4 for VXLAN tunneling.
encapsulation dot1q	Sets VLAN ID to logically multiplex Ethernet subinterfaces or port-channel subinterfaces on VLAN Tag.
interface vxlan	Sets VTEP of VXLAN.
member vni	Set VNI belonging to the relevant VTEP.
source-interface	Configures the source interfaces to be attached to VXLAN frames.
switchport	Enables or disables the Layer 2 interface configuration.
vxlan enable	Enables VXLAN function.
vxlan pmtu	Enables VXLAN PMTU function of the Switch and sets the thresholds for sending Path MTU Discovery.
vxlan pmtu enable	Enable VXLAN PMTU feature on the applicable interfaces.
vxlan vlan-mapping mode	Sets the capacity limit to be extended when VLAN mapping is selected for VNI mapping method.
vxlan-vni	Map VNI to a VLAN or subinterface.
interface gigabitethernet^#1	Set the items related to the Ethernet interface whose max line speed is 1000Mbit/s.
interface hundredgigabitethernet^#1	Set the items related to the Ethernet interface whose max line speed is 100Gbit/s.
interface tengigabitethernet^#1	Set the items related to the Ethernet interface whose max line speed is 10Gbit/s.
interface port-channel^#2	Sets an item related to a port channel interface.