21.2.1 List of configuration commands
The following table lists the commands used to configure the basic link aggregation functionality.
Command name |
Description |
---|---|
channel-group lacp system-priority |
Sets the LACP system priority for each channel group. |
channel-group mode |
Adds a port to a channel group. |
channel-group periodic-timer |
Sets the LACPDU sending interval. |
description |
Sets supplementary information about a channel group. |
interface port-channel |
Sets up a port channel interface. The parameters of a channel group are also set in port channel interface configuration mode. |
lacp port-priority |
Sets the LACP port priority. |
lacp system-priority |
Sets the default for the LACP system priority. |
port-channel load-balance |
Specifies the allocation method. |
shutdown |
Stops communication for a channel group |
system port-channel load-balance-all-port # |
Ports of all member switches are subject to port distribution when frames are sent. |
- #
-
See "Managing Vol.1" "10 Appliance" in the Configuration Command Reference.