20.3.11 Configuring Sync-E

Enable Sync-E and set the incoming port number for the external clocks.

Points to note

Sync-E is enabled by setting the reception port number of the external clock. In this example, 1/0/1 is set for the port with the higher priority as the receiving port of the external clock, and 1/0/2 is set for the port with the lower priority.

Command examples

1. (config)# network-clock input-source 1 interface tengigabitethernet 1/0/1

   Enable Sync-E and set the receive port of the external clock to 1/0/1 with priority 1.

2. (config)# network-clock input-source 2 interface tengigabitethernet 1/0/2

   Sets 1/0/2 as the receive port of the external clock with priority 2.