20.3.1 List of configuration commands

The following table lists the commands used to configure Ethernet.

Table 20-19: List of configuration commands
Command name	Description
bandwidth	Sets the bandwidth.
description	Sets supplementary information.
duplex	Sets duplex mode.
flowcontrol	Sets flow control.
frame-error-notice	Sets the condition for sending a notification when a frame reception error or a frame sending error occurs.
interface fortygigabitethernet	Specifies an Ethernet internet configuration with a maximum line speed of 40 Gbit/s. For models that implement stack-only ports, this command is set only when the stack feature is enabled.
interface gigabitethernet	Specifies an Ethernet internet configuration with a maximum line speed of 1000 Mbit/s.
interface hundredgigabitethernet	Specifies the configuration of the Ethernet interface with the highest line speed 100Gbit/s.
interface tengigabitethernet	Specifies the configuration of the Ethernet interface with the highest line speed 10Gbit/s.
link debounce	Sets the time required before a link-down is detected.
link up-debounce	Sets the time required before a link-up is detected.
mdix auto	Set the auto MDI/MDIX function.
mtu	Sets the Ethernet MTU.
network-clock input-source	Enable Sync-E and configure the incoming port for the external clocks.
network-clock preempt-delay	Sets Sync-E auto-switch-back suppression period.
shutdown	Shuts down Ethernet.
speed	Sets the speed.
system flowcontrol off	The example below shows how to disable flow control for all ports on the switch.
system mtu	Sets a value for an Ethernet MTU device.