20.2.3 Jumbo Frames
Jumbo frames are a function for relaying frames whose DA to data in MAC headers exceeds 1518 octets. In addition to using jumbo frames, you can also increase the fragment size of IP packets by using the ip mtu configuration command to change the MTU value.
The Switch supports only frames in Ethernet V2 format. IEEE802.3 format frames are not supported. For information on Tagged frames, see Formatting Tagged Frames in 24.1.5 VLAN Tag. The following table describes the jumbo frame support status.
Item |
Frame format |
Description |
|
---|---|---|---|
Ethernet V2 |
IEEE 802.3 |
||
Frame size (octets) |
1519~9234 |
NG |
DA to length of MAC headers. (FCS excluded). |
Reception |
OK |
NG |
Frames in IEEE 802.3 format are discarded when the value of the LENGTH field is 0x05DD (1501 octets) or larger. |
Sending |
OK |
NG |
Frames in IEEE 802.3 format are not sent. |
Legend: OK: Supported, NG: Not supported
Note that 10BASE-T/100BASE-TX/1000BASE-T supports only 100BASE-TX (full duplex) and 1000BASE-T (full duplex).