18.2.1 List of configuration commands
The following tables list the commands used to configure SNMP/RMON.
Command name |
Description |
---|---|
hostname |
Sets the host name of a Switch. This setting is equivalent to sysName defined in RFC 1213. |
rmon alarm |
Sets the control information of the RMON (RFC 1757) alarm group. |
rmon collection history |
Sets the control information for the statistical history for RMON (RFC 1757) Ethernet. |
rmon event |
Sets the control information for an RMON (RFC 1757) event group. |
snmp-server community |
Sets the access list for the SNMP community. |
snmp-server contact |
Sets the contact information of the Switch. This setting is equivalent to sysContact defined in RFC 1213. |
snmp-server engineID local |
Sets SNMP engine ID information. |
snmp-server group |
Sets SNMP security group information. |
snmp-server host |
Registers the network-management unit (SNMP manager) of the destination to which SNMP notifications are sent. |
snmp-server informs |
Sets the conditions for resending informs. |
snmp-server location |
Sets the name of the location where the Switch is installed. This setting is equivalent to sysLocation defined in RFC 1213. |
snmp-server traps |
Sets the sending timing of SNMP notification. |
snmp-server user |
Sets SNMP security user information. |
snmp-server view |
Sets MIB view information. |
snmp trap link-status |
Suppresses sending of SNMP notifications (linkUp or LinkDown) when a line is linked up or down. |