17.2.3 Configure syslog Outputting to VRF in Logging [SL-L3A]

Points to note

Configures a switch so that it uses the syslog output functionality to send the log information to the syslog server in VRF.

To specify a VRF, the log output destination must be specified as an IPv4 or IPv6 address. VRFs cannot be specified by host name.

Command examples

1. (config)# logging host 128.1.1.2 vrf 2

   Configures a switch so that a log is output to IP address 128.1.1.2, VRF ID 2.