14.1.9 Enabling both IPv4 or IPv6 multicasting and IGMP or MLD snooping

Setting the swrt_multicast_table configuration command allows you to use both IPv4 and IPv6 multicasting and IGMP or MLD snooping with the Switch.

You can check whether swrt_multicast_table is set by using the show system operation command.

Points to note

By default, swrt_multicast_table is not set. After you set it, you must restart the Switch to apply the setting. For this reason, we recommend that you perform the setting at initial deployment.

Command examples

1. (config)# swrt_multicast_table

   In configuration mode, sets swrt_multicast_table.

2. (config)# save

   (config)# exit

   Saves the settings and switches from configuration mode to administrator mode.

3. # reload

   Restarts the Switch.