9.2.1 List of configuration commands
The following table lists the commands used to configure the management port.
Command name |
Description |
---|---|
description |
Sets supplementary information. |
duplex |
Sets the management port duplex. |
interface mgmt |
Specifies the configuration of the management port. |
ip routing |
Specifies whether IPv4 can be forwarded at Layer 3 on the management port. |
ipv6 routing |
Specifies whether IPv6 can be forwarded at Layer 3 on the management port. |
shutdown |
Shuts down the management port. |
speed |
Sets the line speed of the management port. |
ip address #1 |
Specifies IPv4 of the management port. |
ipv6 address #2 |
Specifies IPv6 of the management port. |
ipv6 enable #2 |
Enables IPv6 function of the management port. This command automatically creates a link-local address. |
- Note #1
-
See "Configuration Command Reference Vol.2" "2 IPv4 .ARP .ICMP".
- Note #2
-
See "Configuration Command Reference Vol.2" "17 IPv6 .NDP .ICMPv6".
The following table lists the commands used to configure the connection and remote operation of operation terminals.
Command name |
Description |
---|---|
ftp-server |
Permits access from remote operation terminals using FTP. |
line console |
Sets parameters for the RS232C port. |
line vty |
Allows remote access to the appliance. |
speed |
Sets the communication speed of the RS232C port. |
transport input |
Regulates access from a remote operation terminal using the various protocols. |
For information about configuring SSH, see 11 SSH(Secure Shell).
For the configuration commands related to VLAN settings and IPv4/IPv6 interface settings, see 24 VLAN, Configuration Guide Vol.3" "2 IP .ARP .ICMP Settings and Operation, or Configuration Guide Vol.3" "19 IPv6 .NDP .ICMPv6 Settings and Operation.