8.2.4 Executing operation commands from the master switch to a member switch

When switch number 1 is the master switch and switch number 2 is the backup switch, the operation command show logging displays member switch logging as shown below. The switch number and switch status are displayed at the beginning.

Figure 8-8: Example of displaying the member switch log for switch number 2
> show logging switch 2 Switch 2 (Backup) ----------------- Wed Jun 22 15:30:00 UTC 20XX System information ... >

You can also use the operation command remote command to execute operation commands on a specified member switch from the master switch. When switch number 1 is the master switch and switch number 2 is the backup switch, remote command command and operation command show clock show the member switch time as shown below. The switch number and switch status are displayed at the beginning.

Figure 8-9: Displaying the member switch time of switch number 2
# remote command 2 show clock Switch 2 (Backup) ----------------- Wed Jun 22 15:30:00 UTC 20XX #

Figure 8-10: Displaying the time of all member switches
# remote command all show clock Switch 1 (Master) ----------------- Wed Jun 22 15:30:00 UTC 20XX Switch 2 (Backup) ----------------- Wed Jun 22 15:30:00 UTC 20XX #