4.1.3 Overview of operation management functions
To begin using the Switch, complete the setup tasks and then power on the Switch. From an operation terminal connected to the Switch, you can execute operation commands and configuration commands to check the device status or to change the configuration as the connected network changes. The following table describes the Switch management operations you can perform.
Functionality |
Overview |
---|---|
Command input |
Accepts input from the command line. |
Login control |
Blocks unauthorized access and performs password checks. |
Configuration editing |
Sets the running configuration. The settings apply immediately. |
Network commands |
Supports remote operation commands. |
Logs and statistics |
Shows information such as past failures and statistics about line usage. |
LED display and fault reporting |
Shows the status of the Switch using LEDs. |
MIB information gathering |
Manages the network via an SNMP manager. |
Switch maintenance |
Provides commands such as displaying statuses for maintaining the switch, and line diagnostics for tracking switch and network failures. |
Memory card tools |
Perform tasks such as formatting memory cards. |