2.12.6 2110XXXX-2120XXXX
This section describes operation messages in which the upper four digits of the message identifier are 2110 to 2120.
Message ID |
Event Level |
Message text |
---|---|---|
Content and response |
||
21100001 |
E3 |
IGMP snooping: IGMP querier changed on VLAN <vlan id> - lost IGMP querier address <ipv4 address>. |
An advertisement (IGMPQuery) from the IGMP querier <ipv4 address >on a VLAN (<vlan id>) has disappeared. The IGMP querier information is deleted. The availability of the IPv4 multicast group member (recipient host) cannot be checked, and IPv4 multicast data forwarding is not properly executed. <vlan id>: VLAN ID <ipv4 address>: IPv4 address [Action]
|
||
21100002 |
E3 |
IGMP snooping: IGMP querier changed on VLAN <vlan id> - new IGMP querier address <ipv4 address>. |
An IGMP querier was changed to <ipv4 address> because a new IGMP querier was identified on the VLAN (<vlan id>). <vlan id>: VLAN ID <ipv4 address>: IPv4 address [Action] None. |
||
21100003 |
E3 |
IGMP snooping: IPv4 address not defined on VLAN <vlan id>, IGMP querier function stopped. |
An IGMP querier on the VLAN (<vlan id>) was stopped because the IPv4 address is not set. <vlan id>: VLAN ID [Action]
|
||
21100004 |
E3 |
IGMP snooping: The number of the IGMP snooping entry exceeded the capacity of this system. |
The number of learned entries used in IGMP snooping exceeds the capacity limit of the switch. [Action] The number of entries exceeds the capacity limit. Review the system configuration and setting so that you can reduce the number of entries. |
||
21100005 |
E4 |
The IGMP snooping entry can't be registered at hardware tables(VLAN:<vlan id> MAC address:<mac address>). |
An IGMP snooping entry cannot be set in a hardware table. <vlan id>: VLAN ID <mac address>: MAC address [Action] Review the system configuration. However, depending on the hardware specification, the setting to the maximum of the capacity limit might not be available. |
||
21100006 |
E3 |
IGMP snooping: Learning of IGMP snooping entries started because a master switch switchover occurred. (aging time = <time> seconds) |
In the stacked configuration, the switch status changed from Backup to Master, and IGMP snooping entry-learning started. <time> Learn Time (sec) [Action] None. |
||
21100007 |
E3 |
IGMP snooping: Learning of IGMP snooping entries finished after a master switch switchover occurred. |
In a stacked configuration, learning of IGMP snooping entries was terminated because the switch status was changed from Backup to Master. [Action] None. |
||
21100008 |
E3 |
IGMP snooping: The number of the dynamic mrouter-port exceeded the capacity of this system. |
Unable to learn because the number of automatically learned multicast router ports exceeds the capacity limit. [Action] Either erase unnecessary multicast router information or review the configuration. |
||
21100009 |
E3 |
IGMP snooping: Multicast router(<type>:<ipv4 address>) found on port <switch no.>/<nif no.>/<port no.> of VLAN <vlan id>. |
A multicast router was detected. <type> Detection method (IGMP,PIM) <ipv4 address>: IPv4 address <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <vlan id>: VLAN ID [Action] None. |
||
21100010 |
E3 |
IGMP snooping: Multicast router(<type>:<ipv4 address>) found on ChGr <channel group number> of VLAN <vlan id>. |
A multicast router was detected. <type> Detection method (IGMP,PIM) <ipv4 address>: IPv4 address <channel group number>: Channel group number <vlan id>: VLAN ID [Action] None. |
||
21100011 |
E3 |
IGMP snooping: Multicast router(<type>:<ipv4 address>) lost on port <switch no.>/<nif no.>/<port no.> of VLAN <vlan id>. |
Removed the multicast router. <type> Detection method (IGMP,PIM) <ipv4 address>: IPv4 address <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <vlan id>: VLAN ID [Action] None. |
||
21100012 |
E3 |
IGMP snooping: Multicast router(<type>:<ipv4 address>) lost on ChGr <channel group number> of VLAN <vlan id>. |
Removed the multicast router. <type> Detection method (IGMP,PIM) <ipv4 address>: IPv4 address <channel group number>: Channel group number <vlan id>: VLAN ID [Action] None. |
||
21200001 |
E3 |
MLD snooping: MLD querier changed on VLAN <vlan id> - lost MLD querier address <ipv6 address>. |
The MLD querier information was deleted because an advertisement (MLD Query) from the MLD querier <ipv6 address >on a VLAN (<vlan id>) disappeared. The IPv6 multicast data will not be properly relayed because the existence of the IPv6 multicast group listener (recipient host) cannot be checked. <vlan id>: VLAN ID <ipv6 address>: IPv6 address [Action]
|
||
21200002 |
E3 |
MLD snooping: MLD querier changed on VLAN <vlan id> - new MLD querier address <ipv6 address>. |
The MLD querier was changed to <ipv6 address> because a new MLD querier was identified on the VLAN (<vlan id>). <vlan id>: VLAN ID <ipv6 address>: IPv6 address [Action] None. |
||
21200003 |
E3 |
MLD snooping: IPv6 address not defined on VLAN <vlan id>, MLD querier function stopped. |
The MLD querier on VLAN (<vlan id>) was stopped because the IPv6 address was not set. <vlan id>: VLAN ID [Action]
|
||
21200004 |
E3 |
MLD snooping: The number of the MLD snooping entry exceeded the capacity of this system. |
The number of learned entries used in MLD snooping exceeds the capacity limit of the switch. [Action] The number of entries exceeds the capacity limit. Review the system configuration and setting so that you can reduce the number of entries. |
||
21200005 |
E4 |
The MLD snooping entry can't be registered at hardware tables(VLAN:<vlan id> MAC address:<mac address>). |
An MLD snooping entry cannot be set in a hardware table. <vlan id>: VLAN ID <mac address>: MAC address [Action] Review the system configuration. However, depending on the hardware specification, the setting to the maximum of the capacity limit might not be available. |