23.2.1 Command list
The following tables list LLDP configuration commands.
|
Command name |
Description |
|---|---|
|
lldp enable |
Enables operation of LLDP for a port. |
|
lldp hold-count |
Specifies how long the LLDP frames sent from the Switch to neighboring devices will be retained on the neighboring devices. |
|
lldp interval-time |
Specifies the interval at which the Switch sends LLDP frames. |
|
lldp management-address |
Set the administrative adress of Management Address TLV to be sent. |
|
lldp run |
Enables LLDP for the entire device. |
The following tables list the operation commands for LLDP.
|
Command name |
Description |
|---|---|
|
show lldp |
Shows the configuration and neighboring device information for LLDP. |
|
show lldp statistics |
Shows LLDP statistics. |
|
clear lldp |
Clears the neighboring device information for LLDP. |
|
clear lldp statistics |
Clears LLDP statistics. |
|
restart lldp |
Restarts the LLDP program. |
|
dump protocols lldp |
Dumps detailed event trace information and control table information collected by the LLDP program to a file. |